Cisco 400-351 Exam Questions – Secret To Pass In First Attempt
The Cisco CCIE Wireless 400-351 practice test software offers you customizable learning so that you can estimate the time required to attempt each question as well as can get acquainted with the pattern of each question and solves the Cisco 400-351 Cisco Certified Internet Expert Wireless CERTIFICATE exam with full confidence to win. No need to think much of it interface Cisco 400-351 exam pratice test software and pattern just download free demo and everything will be clear. Pay through MacAfee Secure payment method to get the instant access of the Cisco 400-351 exam questions.
400-351 exam questions, 400-351 PDF dumps; 400-351 exam dumps:: https://www.dumpsschool.com/400-351-exam-dumps.html (274 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate Cisco 400-351 Dumps Exam Questions and Answers:
Which action is needed to edit the settings of an RF profile?
A. Disable both radio networks
B. Disable custom power level settings for all APs within the group to which the profile is linked.
C. Remove the desired RF profile from all AP groups
D. RF profiles cannot be edited. They must be removed and recreated with the desired values.
You are designing a wireless network for a museum. One of their requirements is to track people inside the museum and push a notification into their tablet device as soon as they step in front of a painting with information about the artist and the painting. This information must be delivered in real time. You are using regular probe request-based tracking and during testing. You notice that although the tablet Is connected to the museum Wi-Fi network, the location is not updating in real time as you move. It can take almost 2 minutes for the location to be updated. Which option is the likely reason for this issue?
A. Cisco MSE does not perform a new location calculation for certain elements if the resulting position is not at least 5 meters different than the previous location.
B. Probe request-based tracking is bound to delay due to the broadcast type of traffic that is not acknowledged over the air and could be lost.
C. CCXv4 S60 is disabled by default. You must enable CCXv4 S60, which is compatible with all Wi-Ficlients. This feature comes out location updates more frequently.
D. Probe request-based tracking is device dependent. The tablet might not send a probe request if it is maintaining a good Wi-Fi signal, which can cause slower location updates.
New Updated 400-351 Exam Questions 400-351 PDF dumps 400-351 practice exam dumps: https://www.dumpsschool.com/400-351-exam-dumps.html
You are getting the following error message. Which reason for this issue true?
%DOT11-4-CANT_ASSOC Interface Dot 11 Radio0. Cannot associate NO Aironet Extension IE.
A. “dot11 extension ” is missing under the interface Dot11Radio 0 interface.
B. When repeater mode is used, unicast-flooding must be enabled to allow Aironet IE communications.
C. The parent AP MAC address has not been defined.
D. Repeater mode only works between Cisco access point.
You have received a new Cisco 5760 Controller and have gone through the initial startup wizard. You are now trying to add APs to the controller, but these are not joining.
Which three checks should you do next? (Choose three.)
A. Check that the radios are not in a shutdown state.
B. Check the country code of the controller. The APs do not join the controller if the country code does not match.
C. Check that the correct time is set on the controller.
D. Check that option 53 has been set in the DHCP scope.
E. Check that the controller has enough AP licenses.
F. Check that the controller has been configured with the correct hostname. Otherwise, DNS resolution fails.
You are installing Converged Access controllers that run Cisco IOS-XE and you are ready to implement QoS. From the below, choose all the possible QoS target levels that would apply to downstream traffic (toward the client)?
A. Client, SSID, Radio, Port
B. Client, SSID, Radio
C. Client, Radio
D. Client, SSID
Which memchanism incorporates the channel capacity into the CAC determination and gives a much more accurate assessment of the current call carrying capacity of the AP?
A. Static CAC.
B. Reserved roaming bandwidth(%).
C. Expedited bandwidth.
D. Metrics collection.
E. Load-based AC.
F. Max RF bandwidth (%).
G. Admission control.